ДСТУ EN 62087-3:2022 Аудіо-, відео та супутнє обладнання. Визначення споживання електроенергії. Частина 3. Телевізори (EN 62087-3:2016, IDT; IEC 62087-3:2015, IDT)

ДСТУ EN 62087-3:2022
(EN 62087-3:2016, IDT; IEC 62087-3:2015, IDT)

Аудіо-, відео та супутнє обладнання. Визначення споживання електроенергії.
Частина 3. Телевізори

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

FOREWORD

INTRODUCTION

1 Scope

2 Normative references

3 Terms, definitions, and abbreviations

3.1 Terms and definitions

3.2 Abbreviations

4 Specification of operating modes and functions

4.1 Table of operating modes and functions

4.2 Configurations and picture settings

4.2.1 Conceptual framework

4.2.2 Selection of home configuration

4.2.3 Selection of retail configuration

5 Measurement conditions

5.1 General

5.2 Power source

5.3 Environmental conditions

5.4 Ambient light conditions

5.5 Measuring equipment

5.5.1 Power measuring instrument

5.5.2 Luminance measuring device

5.5.3 Illuminance measuring instrument

5.6 Signal generation

5.6.1 Equipment

5.6.2 Interfaces

5.6.3 Accuracy

5.6.4 Light source for specific illuminance levels

5.6.5 Light source for disabling the ABC feature

5.6.6 Networking equipment

6 Procedures

6.1 Order of activities

6.2 Preparation

6.2.1 Measuring plan

6.2.2 Power source voltage and frequency

6.2.3 Input terminals

6.2.4 Video signal, On mode power consumption procedure

6.2.5 Video signal, peak luminance ratio determination

6.2.6 Video format

6.2.7 Automatic brightness control capabilities

6.2.8 Automatic brightness control levels

6.2.9 Network connection capabilities

6.3 Initial activities

6.3.1 Order of initial activities

6.3.2 Cool down

6.3.3 Main batteries

6.3.4 Plug-in module

6.3.5 Installation

6.3.6 Application of input signals

6.3.7 Luminance measuring device setup

6.3.8 Light source setup

6.3.9 Power on

6.3.10 TV settings

6.4 Determination of power consumption, On mode

6.4.1 Order of activities

6.4.2 Stabilization

6.4.3 Television sets without automatic brightness control enabled by default

6.4.4 Television sets with automatic brightness control enabled by default

6.4.5 Power measurement

6.5 Determination of peak luminance ratio and power factor

6.5.1 General

6.5.2 Activities for peak luminance ratio and power factor determination

6.6 Determination of power consumption, Partial On mode

6.6.1 General

6.6.2 Order of activities

6.6.3 AV inputs

6.6.4 Standby-passive

6.6.5 Standby-active, low

6.7 Determination of power consumption, Off mode

6.7.1 Connections and networking

6.7.2 Availability

6.7.3 Measurement

Annex A (informative) Considerations for On mode television set power measurements

Annex B (normative) Test report

Annex C (informative) Example test report template

Bibliography