ДСТУ EN ISO 22153:2022 Електричні приводи для промислової арматури (EN ISO 22153:2021, IDT; ISO 22153:2020, IDT)

ДСТУ EN ISO 22153:2022
(EN ISO 22153:2021, IDT; ISO 22153:2020, IDT)

Електричні приводи для промислової арматури. Загальні вимоги

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

1 Scope

2 Normative references

3 Terms and definitions

4 Classification — Designation

4.1 General

4.2 Type

4.3 Actuator duty classification

4.4 Action on loss of external electric power

4.4.1 Stay put action

4.4.2 Fail-safe action

5 Design requirements

5.1 Endurance

5.1.1 General

5.1.2 Part-turn actuators

5.1.3 Multi-turn actuators

5.1.4 Linear actuators

5.2 Environmental conditions

5.2.1 General

5.2.2 Ambient temperature and humidity

5.2.3 Altitude

5.2.4 Enclosure protection

5.2.5 External corrosion protection

5.2.6 Vibrations, shock and seismic conditions

5.3 Actuator attachment

5.3.1 Part-turn actuators

5.3.2 Multi-turn actuators

5.3.3 Linear actuators

5.4 Primary closing direction

5.5 Fail-safe direction

5.6 Electrical connections — Cable entries

5.7 Self-locking/braking

5.8 Performance

5.8.1 Power supply tolerances

5.8.2 Actuator duty performances

5.8.3 Operating time and speed

5.9 Basic design requirements

5.9.1 Motors

5.9.2 Gearing lubricant

5.9.3 Manual operation

5.9.4 Travel limitation

5.9.5 Torque/thrust limitation

5.9.6 Structural integrity

5.9.7 End stop adjustment for part-turn and linear actuators

5.9.8 Noise

6 Optional equipment

6.1 General

6.2 Anti-condensation heater

6.3 Position transmitter

6.4 Actuator running transmitter

6.5 Additional position and/or torque signalling

6.6 Local control station

6.7 Local position indication

6.8 Actuator electrical controls

6.8.1 General

6.8.2 Positioner

6.8.3 Controller

6.8.4 Speed control

6.8.5 Field bus system interface

6.8.6 Torque transmitter (analogue or digital)

6.8.7 Actuator performance data logger

7 Type and production test

7.1 General

7.2 Type tests

7.3 Control of production process

8 Marking

8.1 General

8.2 Mandatory marking

8.3 Optional marking

9 Documentation

9.1 General

9.2 Mandatory documentation

9.3 Optional documentation

10 Packaging

Annex A (normative) Endurance test procedure

Annex B (informative) Actuator selection guidelines

Annex C (informative) Load profiles

Bibliography