ДСТУ EN 12602:2022 Конструкції армовані заводського виготовлення з автоклавного ніздрюватого бетону (EN 12602:2016, IDT)

ДСТУ EN 12602:2022
(EN 12602:2016, IDT)

Конструкції армовані заводського виготовлення з автоклавного ніздрюватого бетону

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

1 Scope

2 Normative references

3 Terms, definitions, symbols and abbreviations

3.1 Terms and definitions

3.2 Symbols

3.3 Abbreviations

4 Properties and requirements of materials

4.1 Constituent materials of autoclaved aerated concrete

4.2 Autoclaved aerated concrete parameters

4.3 Reinforcement

4.4 Bond

4.5 Thermal prestress

5 Properties and requirements of components

5.1 General

5.2 Technical requirements and declared properties

5.3 Durability

6 Assessment and verification of constancy of performance – AVCP

6.1 Introduction

6.2 Type testing

6.3 Factory production control (FPC)

7 Basis for design

7.1 Design methods

7.2 Limit states

7.3 Actions

8 Marking, labelling and designation

8.1 Standard designation

8.2 Production detail information

8.3 Additional information on accompanying documents

Annex A (normative) Design by calculation

Annex B (normative) Design by testing

Annex C (normative) Resistance to fire design of AAC components and structures

Annex CA (normative) Modulus of elasticity and maximum strain of AAC and reinforcing steel at elevated temperature

Annex CB (informative) Joints between AAC components satisfying resistance to fire E

Annex CC (normative) Temperature profiles of AAC wall, floor and roof components and AAC beams

Annex CD (normative) Resistance to fire tabulated data for walls with mechanical impact

Annex D (informative) Recommended values for partial safety factors

Annex E (informative) Recommendations for the consideration of prestress in the design of prefabricated reinforced AAC components

Annex F (informative) Statistical methods for quality control

Annex G (normative) Factory production control of stainless reinforcing steel based on at least three samples – Minimum acceptance criteria for individual values and corresponding mean values

Annex H (informative) Methods for declaring the mechanical and fire resistance performances in ENs for structural elements

Annex ZA (informative) Relationship of this European Standard with Regulation (EU) No.305/2011

Bibliography