ДСТУ EN ISO 19085-12:2022 Верстати деревообробні. Безпека. Частина 12. Верстати для шипорізання/профілювання (EN ISO 19085-12:2021, IDT; ISO 19085-12:2021, IDT)

ДСТУ EN ISO 19085-12:2022
(EN ISO 19085-12:2021, IDT; ISO 19085-12:2021, IDT)

Верстати деревообробні. Безпека. Частина 12. Верстати для шипорізання/профілювання

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 List of significant hazards

5 Safety requirements and measures for controls

5.1 Safety and reliability of control systems

5.2 Control devices

5.3 Start

5.4 Safe stops

5.5 Braking function of tool spindles

5.6 Mode selection

5.7 Spindle speed changing

5.8 Failure of any power supply

5.9 Manual reset control

5.10 Enabling control

5.11 Machine moving parts limited speed monitoring

5.12 Time delay

5.13 Tele-service

6 Safety requirements and measures for protection against mechanical hazards

6.1 Stability

6.2 Risk of break-up during operation

6.3 Tool holder and tool design

6.4 Braking

6.5 Safeguards

6.6 Prevention of access to moving parts

6.7 Impact hazard

6.8 Clamping devices

6.9 Measures against ejection

6.10 Work-piece support and guides

7 Safety requirements and measures for protection against other hazards

7.1 Fire

7.2 Noise

7.3 Emission of chips and dust

7.4 Electricity

7.5 Ergonomics and handling

7.6 Lighting

7.7 Pneumatics

7.8 Hydraulics

7.9 Electromagnetic compatibility

7.10 Laser

7.11 Static electricity

7.12 Errors of fitting

7.13 Isolation

7.14 Maintenance

7.15 Heat

7.16 Substances

8 Information for use

8.1 Warning devices

8.2 Marking

8.3 Instruction handbook

Annex A (informative) Performance levels required

Annex B (normative) Tests for braking function

Annex C (normative) Stability test for displaceable machines

Annex D (normative) Impact test for guards

Annex E (normative) Noise emission measurement for single end profiling machines

Bibliography