ДСТУ EN ISO 19085-16:2022 Верстати деревообробні. Безпека. Частина 16. Настільні стрічкові пилки та стрічкові пилки (EN ISO 19085-16:2021, IDT; ISO 19085-16:2021, IDT)

ДСТУ EN ISO 19085-16:2022
(EN ISO 19085-16:2021, IDT; ISO 19085-16:2021, IDT)

Верстати деревообробні. Безпека. Частина 16. Настільні стрічкові пилки та стрічкові пилки

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Safety requirements and measures for controls

4.1 Safety and reliability of control systems

4.2 Control devices

4.3 Start

4.4 Safe stops

4.5 Braking function of tools

4.6 Mode selection

4.7 Tool speed changing

4.8 Failure of any power supply

4.9 Manual reset control

4.10 Standstill detection and monitoring

4.11 Machine moving parts speed monitoring

4.12 Time delay

4.13 Teleservice

5 Safety requirements and measures for protection against mechanical hazards

5.1 Stability

5.2 Risk of break-up during operation

5.3 Tool and tool fixing design

5.4 Braking

5.5 Safeguards

5.6 Prevention of access to hazardous moving parts

5.7 Impact hazard

5.8 Clamping devices

5.9 Measures against ejection

5.10 Workpiece supports and guides

5.11 Safety appliances

6 Safety requirements and measures for protection against other hazards

6.1 Fire

6.2 Noise

6.3 Emission of chips and dust

6.4 Electricity

6.5 Ergonomics and handling

6.6 Lighting

6.7 Pneumatics

6.8 Hydraulics

6.9 Electromagnetic compatibility

6.10 Laser

6.11 Static electricity

6.12 Errors of fitting

6.13 Isolation

6.14 Maintenance

6.15 Relevant but not significant hazards

7 Information for use

7.1 Warning devices

7.2 Marking

7.3 Instruction handbook

Annex A (informative) List of significant hazards

Annex B (informative) Performance level required

Annex C (normative) Stability test

Annex D (normative) Test for braking function

Annex E (normative) Impact test for guards

Annex F (normative) Noise test code

Annex G (normative) Rigidity test of the adjustable guard above the cutting area of the band saw blade