ДСТУ EN 60168:2022 Испытание внутренних и внешних опорных изоляторов из керамического материала или стекла для систем с номинальным напряжением свыше 1 кВ (EN 60168:1994, IDT; IEC 60168:1994, IDT). С Изменени...

Foreword

Introduction

Section 1. General

1.1 Scope and object

1.2 Normative references

1.3 Definitions

Section 2. Insulators

2.1 Insulator designs and insulating materials

2.2 Values which characterize a post insulator

2.3 Identification of insulators

Section 3. Classification of the tests, sampling rules and procedures

3.1 Classification of the tests

3.2 Quality assurance

3.3 General requirements for type tests

3.4 General requirements for sample tests

Section 4. Test procedures for electrical tests

4.1 General requirements for high-voltage tests

4.2 Standard atmospheric conditions and correction factors for electrical tests

4.3 Artificial rain parameters for wet tests

4.4 Mounting arrangements for electrical tests

4.5 Dry lightning-impulse withstand voltage test - Type test

4.6 Dry or wet switching-impulse withstand voltage tests - Type test

4.7 Dry power-frequency withstand voltage test - Type test (applicable only to post insulators for indoor use)

4.8 Wet power-frequency withstand voltage test - Type test (applicable only to post insulators for outdoor use)

4.9 Puncture test - Sample test

4.10 Routine electrical test

Section 5. Test procedures for mechanical and other tests

5.1 Verification of the dimensions - Type and sample test

5.2 Mechanical failing load test - Type and sample test

5.3 Test for deflection under load - Special type test

5.4 Temperature cycle test - Sample test

5.5 Routine thermal shock test (applicable only to toughened glass insulating parts)

5.6 Porosity test - Sample test (applicable only to ceramic post insulators)

5.7 Galvanizing test - Sample test

5.8 Routine visual inspection

5.9 Routine mechanical test

Section 6. Tests applicable to post insulators

6.1 Type tests

6.2 Sample tests

6.3 Routine tests

6.4 Summary of tests on post insulators

Annex A (informative) Methods of testing for tolerances of parallelism, eccentricity, angular deviation, camber and shed angle of post insulators

Annex В (informative) Methods of routine testing of unassembled insulator units

Annex C (informative) Bibliography

Annex ZA (normative) Other international publications quoted in this standard with the references of the relevant European publications